15
5/18 REV 12/22
GB743SHVT5 INSTALLATION TOOL: S/N: 1008 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
OVERHAUL
POPPET VALVE ASSEMBLY (703651)
WARNING
:
Disconnect tool from its power source before poppet valve assembly (703651) removal or installation. Severe
personal injury may occur if power source is not disconnected.
CAUTION:
Use caution when removing the poppet valve assembly (703651) from the handle assembly (700343).
CAUTION:
Ensure all parts are assembled properly and correctly fastened to the tool before using.
Top Hole locates on dowel
Bottom Hole locates on
poppet valve assembly
Poppet valve assembly sits
flush against pin dia. in hole
REMOVING POPPET VALVE ASSEMBLY (703651)
1.
Loosen and remove set screw and lever from handle assembly (700343).
2.
Remove pin from handle assembly (700343).
3.
Pull poppet valve assembly (703651) from handle assembly (700343). If unable to remove
by hand, pull out using pliers being careful not to compromise the poppet valve assembly
(703651).
INSTALLING POPPET VALVE ASSEMBLY (703651)
1.
After replacing o
’
rings on poppet valve, insert poppet valve assembly (703651) into handle
assembly (700343) (note direction in picture provided) and push with thumb until it stops.
2.
Reinsert pin into hole on handle assembly (700343).
3.
Re
-
attach the lever and tighten set screw.
Note: View above shows proper orientation of lever.
HOLE FOR POPPET
VALVE ASSEMBLY
HOLE FOR PIN
PROTRUDING FROM
HANDLE ASSEMBLY
