GADLEE GTS 1250, Operator'S Manual

Page: 29 / 40

ENGLISH
9
•
Lift the batteries from the compartment using suitable lifting equipment.
5.4.4. The battery charger

IMPORTANT
Never allow the batteries to become excessively flat as this could damage them
irreparably.
5.4.5. Choosing the battery charger
Make sure the battery charge is compatible with the batteries to be charged:
−
Wet batteries: : An Automatic Charger Is Recommended
−
Gel batteries: use a charger specific for this type of battery.
Consult the battery charger manufacturer and manual to confirm the choice.
5.4.6. Preparing the battery charger
If you wish to use a battery charger not provided with the machine, you must fit it with the
connector supplied with the machine.
To install the connector, proceed as follows:
•
Remove about 13 mm of protective sheath from the red and black wires of the battery
charger;
•
Insert the wires into the connector contacts and squeeze them forcefully with suitable
pliers;
•
Respect the polarity (red wire + black wire -) when inserting the wires into the
connector.
•
Insert the wired-up connector into the connector(fig. A, ref 5) on the machine.
5.5. Lifting and transporting the machine

IMPORTANT
All phases must be performed in an adequately lit room and adopting the safety
measures most appropriate to the situation.
The operator must always use personal protection devices.
To load the machine onto a means of transport, proceed as follows:
•
Empty the debris bin;
•
Place the machine on the pallet and fix it with plastic straps or metal brackets;
•
Lift the pallet (with the machine) using a fork lift truck and load it onto the means of
transport;
•
Anchor the machine to the means of transport with cables connected to the pallet and
machine itself.