GADLEE GTS 1250, Operator'S Manual

Page: 27 / 40

ENGLISH
7
5.
HANDLING AND INSTALLATION
5.1. Lifting and transporting the packaged machine

IMPORTANT
During all lifting operations, make sure the packaged machine is firmly anchored to
avoid it tipping up or being accidentally dropped.
Always load/unload lorries in adequately lit areas.
The machine, packaged on a wooden pallet by the Manufacturer, must be loaded using
suitable equipment (see EC Directive 2006/42 and subsequent amendments and/or
additions) onto the transporting vehicle. At destination, it must be unloaded using similar
means.
A fork lift truck must always be used to lift the packaged body of the machine. Handle
with care to avoid knocking or overturning the machine.
5.2. Checks on delivery
When the carrier delivers the machine, make sure the packaging and machine are both
whole and undamaged. If the machine is damaged, make the carrier is aware of the
damage and before accepting the goods, reserve the right (in writing) to request
compensation for the damage.
5.3. Unpacking

IMPORTANT
When unpacking the machine, the operator must be provided with the necessary
personal protection devices (gloves, goggles, etc) to limit the risk of accident.
Unpack the machine as follows:
•
Cut and remove the plastic straps using scissors or nippers;
•
Remove the cardboard;
•
Depending on the model, remove the metal brackets or cut the plastic straps fixing the
machine chassis to the pallet;
•
Using a sloping ramp, push the machine backwards off the pallet;
•
Unpack the brushes;
•
Clean the outside of the machine in respect of safety regulations;
•
Once the machine is clear of the packaging, the batteries can be installed.
The packaging may be kept as it can be reused to protect the machine if it is moved to
another site or to a repair workshop.
Otherwise it must be disposed off in compliance with current legislation.
!
DANGER
Failure to observe these instructions could cause possibly serious damage to people
and things and invalidates the guarantee.
5.4. Batteries
Two different types of battery may be installed on these machines:
•
Wet batteries: the electrolyte level must be checked regularly. When necessary, top
up with distilled water until the plates are covered. Do not over fill (5 mm max. Above
the plates).
•
Gel batteries: this type of battery requires no maintenance.
The technical characteristics must correspond to those indicated in the paragraph on the
technical specification of the machine. The use of heavier batteries could seriously