Installation Instructions
3
3. Flip the box upside down to allow the heater to stand on its feet and remove the carton. Please check that it is the
correct model and is in good condition.
Check that all parts have been delivered and are intact:
- 1 ECOMBIHHR heater casing.
- 1 Bag containing 2 screws and 2 rawl plugs and 4 white screws.
- 2 supporting feet.
- 1 top fixing fitting.
- 2 side fixing fittings.
- This Guide
The casing and storage bricks are supplied separately. Check the supplied brick packages correspond
to the ones indicated on the heater carton.
The heater operation is not affected if bricks with minor damage are used.
4. Place the heater in the chosen installation area then using the brackets as a template, mark the drill holes on the
wall using a pencil.
5. Drill the marked holes. Place the Rawl plugs into the wall, position the bracket correctly so the holes line up, then fit
the screws tightly. IT MUST NOT BE HUNG ON THE SCREWS; these are used only to stop the device from
overturning and not to support it. If there is any doubt concerning the wall strength contact the corresponding
construction specialist. It is the installer’s responsibility to ensure the correct installation of these devices to prevent
them from overturning.
6. Take off the front outlet grill by removing the four screws. Take off the front panel by removing the two screws
located at the bottom.
7. Connect the heater using the wiring diagram included at the end of the installation instructions. Tighten the
connection block screws securely. Do not leave any remaining wire inside the heater.
WARNING Touching live connections can cause death from electric shock.
