and the running belt will increase, and the load output power will increase. As a result, the running board may
be caused and the running belt surface is severely worn. (Motor, inverter, roller, motor belt, etc.) The entire
drive system is seriously damaged. This damage is not covered by the warranty.
2. At least one inspection of the running condition of the running board and the running belt must be carried out
every week. Please increase the oil according to the actual frequency of the treadmill of the fitness club. (If the
frequency of each machine is 6 hours or more per day, add oil every 10 days or so, each time is increased by
about 50ml each time. If the frequency of each machine is less than 6 hours per day, every 15 days Add oil to
the left and right, each time adding about 50ml each time.
Remember: Do not use oil excessively. It’s not right that he more lubricant, the better. Reasonable
lubrication is an important factor to improve the service life of the treadmill.
3. Lubricating oil increase method:
●
Use oil cans and tubing to add lubricating oil from both sides of the running belt to the standing area of the
user's feet;
●
Start the treadmill, the treadmill runs slowly at a speed of 1KM/, and the user walks on the running belt so
that the lubricating oil can be evenly spread on the running belt.
Remember:
●
Do not use lubricant excessively. The more lubricant, the better. Reasonable lubrication
is an important factor to improve the service life of the treadmill.
●
Be sure to run at low speed after adding lubricating oil, avoid running the belt to break the
lubricating oil into the motor during high-speed operation, causing the motor to short-circuit and damage the
motor;
4. Determine the amount of friction:
Uncleanness or reduced lubricant can cause increased friction between the running board and the running
belt, and may cause damage to the motor and the inverter. The friction is too large and has the following
characteristics:
(1) In the power-off state, using the foot to move the running belt, it feels very difficult, even unable to
move.
(2) The treadmill is unloaded normally, and the speed is obviously slow or irregularly stopped during load.
(3) The frictional force increases, which may cause wear of the running belt, the motor control board is
damaged, the overload protector operates, and the inverter protects.
5. Running belt deviation adjustment:
The treadmill should be adjusted before and after the installation. After using for a period of time, the
running belt may run off. The reasons for this phenomenon are as follows:
(1) The main unit is not placed smoothly.
(2) When the user is exercising, the feet are not in the center area of the running belt.
6. The phenomenon of deviation caused by man-made can resume normal after two to three minutes of no-load
operation. For the deviation phenomenon that cannot be automatically recovered, apply the special tool (M8L
type wrench) that is equipped with the adjustment screw in the rear screw hole in units of a quarter turn
(ninety degrees).
7. Specific adjustment method: If the running belt is biased to the left, adjust the adjusting screw
on the left
clockwise or adjust the adjusting screw on the right counterclockwise. If the running belt is biased to the right,
adjust the adjusting screw on the right or counterclockwise. Adjust the adjustment screw on the left and
recommend adjusting it to ninety degrees (one quarter turn) each time.
The running belt deviation is not covered by the warranty. It is mainly maintained by the user.
The running belt will seriously damage the running belt. It must be discovered in time and
