Fysic FDC-250, User Manual

Page: 5 / 20

-5-
Batteries: (size AA, penlite LR-6, 1.5V, 4x, excluded)
1. Remove the protective cover by flipping off the
cover using a screwdriver underneath the clip.
2. Remove the battery cover by unscrewing the
4 small screws.
3. Install the batteries, paying attention to the +
and -. Preferably, use Alkaline batteries.
4. Replace the battery cover onto the outdoor
unit, fasten it with the 4 small screws and
replace the protective cover.
5. Click the battery compartment into the bottom
of the outdoor unit.
Power adaptor: (8~12V AC or DC, 1000mA, excluded)
1. Remove the seal cover by unscrewing the 4 small screws.
2. Connect the 8-12V adaptor according to the illustration below.
3. Fasten the seal cover back onto the outdoor unit.
First, strip the insulation approximately 1cm.
You may ignore the (+) and (-) connection.
Push in the wire and fix it.
You may hide the connection for the battery compartment with the supplied rubber
panel with bonding strip. Remove the protective layer of the rubber panel en stick it
onto the bottom covering the connections.
1 2 3 4 5
DC Power
AC 8V
AC
8
V
Lock AC Power
Lock
8-12V~
8-12V
of
DC Power
AC 8V
AC
8
V
Lock AC Power
Lock
8-12V~
8-12V
of