16
Chute Directional Control
The chute directional control is located on the left side of the snow thrower.
To change the direction in which snow is thrown, turn chute directional control as follows:
•
Crank clockwise to discharge to the right.
•
Crank counterclockwise to discharge to the left.
Chute Deflector control
The chute deflector controls the snow throwing height. Raise or lower the deflector to the desired
height of snow stream by pushing chute directional control lever.
Clean-out Tool
The chute Clean-out Tool is conveniently fastened to the rear of the auger housing with a
mounting clip. It is used to clean the chute assembly and chute opening when snow and ice
become lodged.
WARNING! Never use your hands to clear a clogged chute assembly. Shut off engine and
remain behind handles until all moving parts have stopped before unclogging.
III-
Assembling and adjusting Your Snow Thrower
Unpack the snow thrower and all its parts, and compare against the list below.
1.
Snow Thrower
2.
Discharge Chute Assembly
3.
Chute Rotation Handle
4.
One Pair of Skid Shoes with hardware
5.
4 Extra Shear Pins and Locknuts
ASSEMBLY
Your Snow Thrower will require some assembly. Please complete the following steps before
using your Snow Thrower.
WARNING:
This snow thrower is heavy. Assembly procedures may
require lifting equipment or two people.
Step 1 – Handle assembly
1.
Attached the upper handle to the lower handle using
(4) knobs, washers and bolts.
Knob, Washer and Bolt
Figure.1
