174
＜ Data ＞
ŶƚƌƗƆƋŃƖƈƏƈƆƗƌƒƑŃƐƈƗƋƒƇ
The various functions used in the T18SZ can be selected by switch. The switch (including when stick,
trim lever, or VR are used as a switch) setting method is common to all functions.
Switch selection
When a switch is selected at a mixing function, etc., the selection screen shown below is called.
(Switch selection screen example)
When switch is selected
Switch ON/OFF setting is possible at each
position.
1. When the ON/OFF "Set" position switch is
tapped after the switch was selected, the
screen shown below appears.
*When the button of each position is tapped,
it toggles between ON and OFF.
2. Tap the button and set to the ON position.
3. Close the screen by tapping [Hardware
select].
When stick, trim lever, or VR is selected.
When a stick, trim lever, or VR is used as a
switch, the following 2 modes can be selected.
ŏ
Mode:
Linear/Symmetry
1. When the ON position button is tapped after
stick, etc. was selected, the screen shown
below appears.
2. Select the mode you want to use, and set it
as described below.
3. Close the screen by tapping [Hardware
select].
Tap the chosen
switch.
Normal or Alternate: Alternate switching
mode is available depending on mixing
function.
