158
＜ Model Menu (Helicopter Functions) ＞
This function is used to adjust the pitch and
the throttle rise characteristic at acceleration/
deceleration operation. An acceleration function
which temporarily increases the pitch and throttle
operations at throttle stick acceleration/deceleration
operation can be set.
Example of acceleration function use
ŏ
When used at pitch, the acceleration
function is effective when you want to
T
uicken the response of the fuselage at 3D
Á
ight
Á
ip, etc.
When used, high pitch temporarily exceeds
maximum pitch, but immediately returns to
maximum pitch.
Setting method
ŏ
Acceleration can be set at both setting
at acceleration (high) and setting at
deceleration (low).
(The operation point is displayed on a
graph.)
ŏ
Acceleration rate setting (Rate)
ŏ
The return time after operation (Damping)
can be set.
Acceleration
ŏ
Select [Acceleration] at the model
menu and call the setup screen shown
below.
Operation up to this
range will initiate
acceleration.
Act position
The rate the angle
increases.
To next page
1/2 : Pitch
2/2 : Throttle
The return time after operation (Damping)
can be set.
（First return）1 〜 100（Slow return）
（Acceleration doesn't function as 0.）
W h e n u s i n g t h i s
function, Tap [INH].
(ON is displayed.)
Condition group/
single mode selection
(Gr. /Sngl)
Current position
ŏ
T h e o p e r a t i o n p o i n t a t a c c e l e r a t i o n
and deceleration can be set. When an
operation point is exceeded, acceleration is
performed.
Note: When using the acceleration function,
since the pitch stroke is large, make your
settings so there is no binding of your linkage.
ŏ
Return to Model menu
