Furuno NXT-600, Operator'S Manual

Page: 5 / 44

SAFETY INSTRUCTIONS
iii
Standard
compass Steering
compass
0.70 m 0.40 m
CAUTION CAUTION
The transducer cable must be handled
carefully, following the guidelines
below.
• Keep fuels and oils away from the
cable.
• Locate the cable away from chemicals.
• Locate the cable away from locations
where it might be damaged.
Do not apply the power with the
transducer exposed to air.
The transducer may be damaged.
A magnetic compass may receive inter-
ference if it is placed too close to the
network fish finder. Observe the com-
pass safe distances shown below to
prevent interference to a magnetic
compass.
WARNING
WARNING
Do not work inside the equipment
unless qualified to do so.
Electricla shock can occur.
Turn off the power before beginning
the installation.
Fire or electrical shock can result if the
power is left on.
Be sure no water leaks at the mounting
location for the transducer and temp-
erature sensor.
Water leakage can sink the vessel. Also,
confirm that neither the transducer nor
the sensor will loosen by vibration. The
installer is solely responsible for the
installation.
Confirm that the power supply voltage
is within the rating of this equipment.
Incorrect voltage will damage the equip-
ment and may cause fire.
The network sounder meets
waterproofing standard IP55. However,
do not install the sounder outdoors.
Fire or electrical shock can result if water
gets inside the equipment.
Safety instructions for the installer