Furuno NXT-600, Operator'S Manual

Page: 16 / 44

2. WIRING
8
5. Loosen two screws to unfasten the clamp fixing plate for the transducer cable.
6. Pass the transducer cable through the sealing nut and super gland and into the unit.
7. Use the WAGO connector opener, attached inside the equipment (see the figure on page 7
for the location), to connect the transducer cable to the WAGO connectors, following the in-
structions in the figure below and the interconnection diagram.
8. Reattach the WAGO connectors to the circuit board.
9. Fasten the clamp fixing plate, referring to the table below for how to orient the plate.
Transducer model Clamp fixing plate orientation
CM265LH/
CM275LH-W Projection on plate upward
B265LH/
B275LH-W Projection on plate downward
Loosen two screws to unfasten cable
clamping plate for transducer cable.
1. Twist conductors.
2. Insert opener as directed and press it down.
3. Insert core to hole.
4. Release opener.
5. Pull the core to make sure it is correctly inserted.
WAGO connector opener
Core
Twist.
Push