Furuno NXT-600, Operator'S Manual

Page: 18 / 44

2. WIRING
10
4. Tighten the lock nut.
5. Tighten the sealing nut until the clearance between the nut and
super gland is 4 mm. The torque for the sealing nut is 1.8 - 2.0
Nm.
6. Position the cable so the vinyl sheath lies in the cable clamp
then use the supplied clamp fixing plate and two upset screws to secure the cable.
7. Pass the cable through the edge saddle shown below then connect the cable to J12 on the
PWRTX board. Be sure the cable does not contact TB4.
Note: For cable MPYC-2, tape the vinyl sheath of the cable (approx. 6 to 7 turns) where it lies
in the cable clamp and fasten the cable clamp. The PH connector has two unused harnesses.
Cut them at their base or wrap them with vinyl tape.
4 mm
Clamp fixing plate
for external KP
Edge saddle
J12
Be sure cable does
not contact TB4.
Taping.
Cut off two unused
harnesses at base.