Furuno NXT-600, Operator'S Manual

Page: 20 / 44

2. WIRING
12
3. Pass the sealing nut, clamping claw and sealing insert onto the LAN cable in the order shown
in the figure below. Connect the cable to the LAN connector. (Note the orientation of the seal-
ing insert when passing it onto the cable. Push the cable into the slit in the sealing insert.)
4. Set the sealing insert and clamping claw into the sealing nut then tighten the nut.
5. Tighten the sealing nut to fasten the LAN cable. The clearance between the sealing nut and
the super gland shall be 3 mm. The torque for the sealing nut is 1.8 - 2.0 Nm.
How to disconnect the LAN cable
Loosen the two screws on the gland to access the cable’s connector. A lock washer is fitted to the
gland, so the screws cannot be unfastened completely.
Sealing nut
LAN cable
Sealing insert
(Push cable into slit.)
Clamping claw
Clearance
Screw (2 pcs.)
Gland