Furuno FSV-85, Installation Manual

Page: 33 / 83

2. WIRING
2-5
LAN cable
Fabricate the supplied LAN cable (FR-FTPC-CY, 10/20/30/50/100 m) as shown be-
low. Cut the vinyl sheath and armor to the lengths shown and attach the modular con-
nector.
Cable jacket
Inner sheath
150
Wrap vinyl tape
Expose inner vinyl sheath. Remove the inner vinyl sheath by
approx. 25 mm. Be careful not to
damage inner shield and cores. Fold back the shield, wrap it onto
the inner vinyl sheath and cut it,
leaving approx. 9 mm.
25 mm
approx. 9 mm
approx. 9 mm
approx. 11 mm
Fold back drain wire and cut it,
leaving approx. 9 mm.
Straighten and flatten the cores
in colored order and cut them,
leaving approx. 11 mm.
Modular plug
Using special crimping tool
MPT5-8AS (PANDUIT CORP.), crimp
the modular plug. Finally, check the
plug visually.
Insert the cable into the modular
plug so that the folded part of the
shield enters into the plug housing.
The drain wire should be located
on the tab side of the jack.
Drain wire
1 WHT/GRN
2 GRN
3 WHT/ORG
4 BLU
5 WHT/BLU
6 ORG
7 WHT/BRN
8 BRN
WHT/ORG 1
ORG 2
WHT/GRN 3
BLU 4
WHT/BLU 5
GRN 6
WHT/BRN 7
BRN 8
[Crossover cable]
1 WHT/ORG
2 ORG
3 WHT/GRN
4 BLU
5 WHT/BLU
6 GRN
7 WHT/BRN
8 BRN WHT/ORG 1
ORG 2
WHT/GRN 3
BLU 4
WHT/BLU 5
GRN 6
WHT/BRN 7
BRN 8
[Straight cable]