Furuno FMD-3200, Installation Manual

Page: 24 / 142

2. WIRING
2-4
Fabricating LAN cable
Fabricate the LAN cable (FR-FTPC-CY, DTI-C5E350 VCV), as shown below. (Wrap
both edges of the armor with vinyl tape.) Confirm that the shield of the cable touches
to the shell of the modular plug.
Note 1: Be sure to use the shielded modular plug that is supplied with the LAN cable.
Note 2: This equipment can use either straight or crossover cables.
Cable jacket Armor
Outer vinyl sheath
Inner vinyl sheath
55 30
Wrap vinyl tape. (width: 20 mm)
1 WHT/GRN
2 GRN
3 WHT/ORG
4 BLU
5 WHT/BLU
6 ORG
7 WHT/BRN
8 BRN WHT/ORG 1
ORG 2
WHT/GRN 3
BLU 4
WHT/BLU 5
GRN 6
WHT/BRN 7
BRN 8
1 WHT/ORG
2 ORG
3 WHT/GRN
4 BLU
5 WHT/BLU
6 GRN
7 WHT/BRN
8 BRN
WHT/ORG 1
ORG 2
WHT/GRN 3
BLU 4
WHT/BLU 5
GRN 6
WHT/BRN 7
BRN 8
[Cross cable] [Straight cable]
Using special crimping tool
MPT5-8AS (PANDUIT CORP.),
crimp the modular plug.
Finally check the plug visually.
Expose inner vinyl sheath.
Remove the inner vinyl sheath
by approx 25 mm. Be careful
not to damage inner shield
and cores.
Fold back the shield, wrap it
onto the inner vinyl sheath
and cut it, leaving 9 mm.
1 2
3
25 mm
approx. 9 mm
4 5
6
approx. 9 mm
approx. 11 mm
Drain wire
Fold back drain wire and
cut it, leaving 9 mm.
Straighten and flatten the
cores in order and cut them,
leaving 11 mm. Insert the cable into the modular
plug so that the folded part of
the shield enters into the plug
housing. The drain wire should
be located on the tab side of
the jack.
7
1
8
Modular plug