4. INSTALLATION
30
4.6
Cable Fabrication
Power cable
Connect the power cable to the power connector. Connect the leads to the battery (12 or 24 VDC);
white to plus(+) terminal and black to minus(-) terminal. Connect the shield to ship’s ground.
Note:
The fuse is not waterproof. Wrap the fuse holder with vinyl tape to keep water out of the
fuse holder.
Transducer cable
Separate the transducer cable well away from power cables to prevent interference. Connect the
cable to the transducer port (for high frequency and/or low frequency) at the rear of the display
unit. Fabricate the cable as below.
BATTERY
Cable connector
Power cable
Lead wire
White
Black
Fuse (3A)
Fuse (3A)
Shield
Vinyl tape
Sheath
Wrap shield around sheath 30 mm and cut
excess shield. Bind this part to the plate.
Extract cores from here and cut inner materials.
Approx. 300
Attach WAGO
connector.
(See next page.)
[Composite transducer]
BLK, RED: L side
BLU, GRN: H side
Note: Never connect the shield to #2 of
the WAGO connector.
Shield
30
8 - 9
Vinyl tape
Approx. 100
Summary of Contents for FCV-288
Page 1: ......
Page 54: ...D 1 27 Apr 2012 Y NISHIYAMA...