Furuno FCV-288, Operator'S Manual

Page: 35 / 56

4. INSTALLATION
27
4.2 Display Unit
Mounting considerations
• Locate the unit out of direct sunlight.
• Select a location where the display screen
can be easily observed while operating the
control panel.
• Leave sufficient space around the unit for
maintenance and servicing. Recommend-
ed maintenance space appears in the out-
line drawings at the back of this manual.
• Locate the unit in a protected area away
from direct exposure to rain and salt spray.
• Observe the compass safe distances on
page ii to prevent deviation of a magnetic
compass.
The display unit is designed to be mounted on
a tabletop. Mount the unit, referring to the out-
line drawings at the back of this manual.
The power cable is connected to the terminal
board in the display unit. Therefore the power
cable can not be disconnected easily like a
connector. So connect the cable to a dedicat-
ed breaker on the mains switchboard.
Preparation for installation
1. Open the back cover.The power cable
and water temperature/speed sensor ca-
ble are tied to a plate with cable ties.Cut
the cable tie which binds the power cable.
2. Put the power cable on the plate and bind
it with a cable tie. If the water tempera-
ture/speed sensor will not be used, leave
the sensor cable as it is. If the water tem-
perature/speed sensor is required, put
the sensor cable on the plate and bind it
with a cable tie.
NOTICE
Do not apply paint, anti-corrosive sealant
or contact spray to coating or plastic
parts of the equipment.
Those items contain organic solvents that
can damage coating and plastic parts,
especially plastic connectors.
WARNING WARNING
Turn off the power at the switchboard
before beginning the installation.
Connect to a dedicated breaker in
the power distributor.
Fire or electrical shock can result if
the power is left on.
Back
cover
Cut
Plate
Power
cable
Sensor
cable
(Rear view)
Unfasten
the screw
and move
the hook.
Power
cable
Sensor cable
(If required.)
Plate
Bind with
cable ties.
50 mm ± 5 mm 50 mm ± 5 mm