Furuno FAR-3220W-BB, Installation Manual

Page: 93 / 185

2. WIRING
2-57
2.7.3 How to set jumper blocks in the sensor adapters
MC-3000S
See the jumper blocks on the MC-CS Board (24P0114) referring to the tables that fol-
low.
MC-CS Board (24P0114)
Rotary switch : Use the rotary switch (S2) to set the Modbus address when setting
connectors J4/J5 to Modbus. The Modbus address set at J4/J5 in the network is not
used. When setting J4/J5 to IEC61162-1/2, use the default setting (“0”).
Jumper block : Use the jumper block J19 to set the termination resistor on/off for the
MODBUS communication on the connector J1. For the first and last sensor adapter in
a series, their termination resistors must be set to ON. Use the MC-CS Board with the
default setting because it becomes the “first” adapter in a series.
Set the jumper blocks J14 through J17 to turn the termination resistors on connectors
J4 through J7, respectively.
Jumper block J19 Connector J1
1-2 SHORT Termination resistor: ON
2-3 OPEN
1-2 OPEN Termination resistor: OFF
(default setting)
2-3 SHORT
S2
J14 J22 J23
J15 J16 J17
J19 J20 J21