Furuno FAR-3220W-BB, Installation Manual

Page: 106 / 185

3. SETTINGS AND ADJUSTMENTS
3-6
5. Use the scrollwheel to set [START] and [ANGLE], referring to the example below.
Spin the scrollwheel to set and push it to confirm.
A solid green line marks the dual radar display area.
• [START] : Start point of the sector (in degrees, 000-359).
• [ANGLE] : Horizontal width of the sector (in degrees, 000-359).
6. Select [3 COMBINE RANGE] to set the vertical width of the sector.
7. Use the scrollwheel to set [START] AND [LENGTH], referring to the example be-
low. Spin the scrollwheel to set and push it to confirm.
• [START] : Distance from reference point to sector
• [LENGTH] : Vertical length of sector
3.5.3 How to select the external radar (image source) to use
1. From the [RADAR INSTALLATION] menu, select [2 SCANNER], [6 DUAL RA-
DAR SETTING].
2. Select [4 EXT RADAR].
3. Select required radar no. (Only the numbers of radar set on the [RADAR INSTAL-
LATION] menu are valid.)
Note 1: The dual radar will not function if a radar incompatible to the dual radar
function is selected.
Note 2: The dual radar display is designed to be used with two FAR-3xx0 series
radars. Other makes or models can be used, however performance may vary.
START
(Example: 130°)
ANGLE
(Example: 100°)
Width of sector
START
LENGTH
Example:
START: 01.00
nm
LENGTH: 02.00 nm