Furuno DFF1-UHD, Operator'S Manual

Page: 23 / 40

2. WIRING
15
12. Transducer cable : Lay the transducer cable in the cable clamp then refasten the clamp fixing
plate.
Cable for the external KP : Lay the cable in the cable clamp and fix it with the supplied clamp
fixing plate and two upset screws.
13. Connect the cables as follows:
• Transducer cable : See section 2.2.2.
• Cable for external KP : See the illustration below. Pass the cable through the edge saddle
and connect the cable to J12 on the PWRTX board. Be sure the cable does not contact TB4.
Note: For cable MPYC-2, tape the vinyl sheath of the cable (approx. 6 to 7 turns) where it lies
in the cable clamp and fasten the cable clamp. The PH connector has two unused harnesses.
Cut them at their base or wrap them with vinyl tape.
Lock nut for super gland (2 pcs.)
Clamp fixing plate
Large: transducer cable
Small: cable for external KP
Edge saddle
J12
Lay vinyl sheath in
cable clamp and
fasten clamp fixing
plate (supplied).
(See step 11.)
Be sure cable does
not contact TB4.
Taping.
Cut off two unused
harnesses at base.