Turn right (clockwise) to tighten
Page 6 of 7
#B x 4 pcs
#D x 4 pcs
#E x 4 pcs
#J x 4 pcs
#B x 8 pcs
#D x 8 pcs
#E x 8 pcs
I.
Align the 2 support rail legs (#8) with the pre-drilled holes of the support rail
(#5).
II.
Prepare 4 bolt assemblies by inserting FIRST the lock washer (#D) onto
the bolt (#B) and then the flat washer (#E) onto the SAME bolt (#B), in that
order.
III.
Insert the bolt assemblies through the pre-drilled holes of the support rail
(#5) and the 2 slat support legs (#8) using the Allen wrench (#H).
IV.
Tighten the 4 hex nuts (#J) onto the same bolts (#B) using the wrench (#I)
to secure the parts together.
I.
Prepare 4 bolt assemblies by
inserting FIRST the lock washer
(#D) onto the bolt (#B) and then
the flat washer (#E) onto the
SAME bolt (#B), in that order.
II.
Insert the bolt assemblies
through the pre-drilled holes of
the right and the left side of the
headboard (#1) using the Allen
wrench (#H) but expose about
½” of the bolts’ threads.
III.
Mount the brackets on the 2 side
rails (#3) onto the bolts (#B).
Make sure all the washers are in
the FRONT of the brackets. Use
the Allen wrench (#H) to further
tighten the bolts to secure the
two parts together.
IV.
Repeat the process above to
assemble the other ends of the 2
side rails (#3) onto the footboard
(#4).
Turn right (clockwise) to tighten
Adjust the levelers on Step 5.
