Page
7
of
7
I.
Align the assembled support rail (#5) with the pre-drilled holes on the center
of the headboard (#1) and the footboard (#4).
II.
Prepare 4 bolt assemblies by inserting FIRST the lock washer (#D) onto the
bolt (#B) and then the flat washer (#E) onto the SAME bolt (#B), in that
order.
III.
Insert the bolt assemblies through the brackets of the support rail (#5) using
the Allen wrench (#H) to lock them with the headboard (#1) and the
footboard (#4).
#B x 4 pcs
#D x 4 pcs
#E x 4 pcs
Turn right (clockwise) to tighten
#F x 13 pcs
#G x 26 pcs
I.
Prepare a bed slat using two
slats (#7), one center connector
(#F) and two end caps (#G).
See diagram for the correct
sequence in connecting those
parts.
II.
Align the two end caps (#G)
with the pre-drilled holes on
each side of the side rails (#3)
and press firmly down on both
end caps (#G) to lock with the
side rails (#3). Then press firmly
down on the center connector
(#F) to lock with the support rail
(#5).
III.
Repeat the process above to
assemble the remaining bed
slats onto the side rails (#3) and
the support rail (#5).
IV.
Make sure the bed is rested on
a flat surface and does not feel
loose or wobbly. If it does,
double check that the
bolts/screws are secured and
properly tightened.
Note: The correct position of the bed
slats should be arcing UPWARD when
placing on the rails.
ASSEMBLY IS COMPLETED
Adjust the levelers according to
the ground level. To lower or to
raise the slat support legs, turn the
leveler clockwise or
counterclockwise, respectively.
