Page
7
of
7
I.
Align the 2 assembled support rails (#5) with the pre-drilled holes on the
headboard (#1) and the footboard (#3).
II.
Prepare 8 bolt assemblies by inserting FIRST the lock washer (#D) onto the
bolt (#B) and then the flat washer (#E) onto the SAME bolt (#B), in that
order.
III.
Insert the bolt assemblies through the brackets of the 2 support rails (#5)
using the Allen wrench (#H) to lock them with the headboard (#1) and the
footboard (#4).
#B x 8 pcs
#D x 8 pcs
#E x 8 pcs
Turn right (clockwise) to tighten
#F x 26 pcs
#G x 26 pcs
I.
Prepare a bed slat using 3 slats
(#7), two center connectors (#F)
and two end caps (#G). See
diagram for the correct
sequence in connecting those
parts.
II.
Align the two end caps (#G)
with the pre-drilled holes on
each side of the side rails (#3)
and press firmly down on both
end caps (#G) to lock with the
side rails (#3). Then press firmly
down on the two center
connectors (#F) to lock with the
two support rails (#5).
III.
Repeat the process above to
assemble the remaining bed
slats onto the side rails (#3) and
the two support rails (#5).
IV.
Make sure the bed is rested on
a flat surface and does not feel
loose or wobbly. If it does,
double check that the
bolts/screws are secured and
properly tightened.
Note: The correct position of the bed
slats should be arcing UPWARD when
placing on the rails.
ASSEMBLY IS COMPLETED
Adjust the levelers according
to the ground level. To lower or
to raise the slat support legs,
turn the leveler clockwise or
counterclockwise, respectively.
