FunkTronic Major 4, Manual

Page: 10 / 31

- 10 -
Kompetent für Elektroniksysteme
automatically adjusted. Therefore, if a change is made from ZVEI 1 to CCIR, the tone length has to
be redened as well. See section Tone Length.
Register 046 1. digit 0 = ZVEI 1
1 = CCIR
2 = ZVEI 2
3 = EEA
4 = ZVEI 3
Tone Table
Tone ZVEI 1 CCIR ZVEI 2 EEA ZVEI 3
0 2400 Hz 1981 Hz 2400 Hz 1981 Hz 2200 Hz
1 1060 Hz 1124 Hz 1060 Hz 1124 Hz 970 Hz
2 1160 Hz 1197 Hz 1160 Hz 1197 Hz 1060 Hz
3 1270 Hz 1275 Hz 1270 Hz 1275 Hz 1160 Hz
4 1400 Hz 1358 Hz 1400 Hz 1358 Hz 1270 Hz
5 1530 Hz 1446 Hz 1530 Hz 1446 Hz 1400 Hz
6 1670 Hz 1540 Hz 1670 Hz 1540 Hz 1530 Hz
7 1830 Hz 1640 Hz 1830 Hz 1640 Hz 1670 Hz
8 2000 Hz 1747 Hz 2000 Hz 1747 Hz 1830 Hz
9 2200 Hz 1860 Hz 2200 Hz 1860 Hz 2000 Hz
A 2800 Hz 2400 Hz 886 Hz 1055 Hz 886 Hz
B 810 Hz 930 Hz 810 Hz 930 Hz 810 Hz
C 970 Hz 2247 Hz 740 Hz 2247 Hz 740 Hz
D 886 Hz 991 Hz 680 Hz 991 Hz 680 Hz
E 2600 Hz 2110 Hz 970 Hz 2110 Hz 2400 Hz
Transmitter Keying
The transmitter can be keyed by the PTT button on the handset or by the red PTT button on the
keypad. The difference between these PTT buttons is the function of the microphones. The PTT
button on the handset switches on the microphone in the handset, and the PTT button on the keypad
switches on the microphone mounted in the housing of the unit. The transmitter is keyed as long
as the PTT button is pressed, except if the TX time out is exceeded. See also seotion TX Time Out
Timer. In the multi-wire Version the transmitter is controlled by optocoupler 1 and, at the same time,
by an open collector output. In the DC Version it is controlled by optocoupler 2, and in AC version by
a keying tone. During call transmission the transmitter is keyed automatically.
TX Time-Out Timer
The TX time-out timer is programmed in one-second intervals at digits 3 to 5 of register 047
(EEPROM 1). Values of '000' up to '255' are permitted. If the programmed value is '000', the TX
time-out timer is out of operation.
PTT Button Blocking
The PTT button blocking is programmed at the fth digit of register 040 (EEPROM 1) as follows:
0 = PTT button blocking is switched off
1 = PTT button is blocked in case of sensed carrier