Battery Installation
Insert battery in the battery
adaptor.
Plug the derailleur wires in to the
battery terminal leads. Either lead
can work for either wire.
Fully insert the battery and adaptor
in the seatpost and check that it is
secure.
1
2
3
Chain Installation
Follow below instruction depending on which cage you use on rear derailleur.
Using short cage
To adjust chain length, use the following procedure if your rear derailleur is mounted with short cage.
1. Install the chain around the big chainring and smallest cog. Route it through rear derailleur cage.
2. In this position, bring the two ends of the chain together until the derailleur cage is vertical.
This is the correct chain length.
3. Use a chain tool to cut the chain to the correct length
Using long cage
To adjust chain length, use the following procedure if your rear derailleur is mounted with long cage.
1. Install the chain around the big chainring and the biggest cog.
2. Pull the chain tight over these two cogs and add one full link (one outer and one inner).
This is the correct chain length.
3. Use a chain tool to cut the chain to the correct length.
Chain lock
If it has not already be done, route the chain through rear derailleur cage.
Follow below operating list for install the Drive Link and lock the chain
1. Insert the plates of the Drive Link on opposing sides of each chain end. (Fig.1) Insert and hook Drive
Link pins into the opposite plate. (Fig.2)
2. To snap Drive Link in locked position, rotate crank until Drive Link is above the chainstay. Hold the rear
brake and firmly push the crank forward. (Fig.3)
Make sure Drive Link snaps in to locked position before use.