With the shifter in SET mode, press the Power
button on the FD until both the LEDs illuminate
blue.
When pairing is complete, the red LED on the
shifter will blink and turn off. The pairing is
complete.
Repeat the procedure for the other shifter.
5
6
7
7. Usage and Adjustments
Power On
Push and hold the power button. The LED lights will blink
red-blue. When the LED lights flash blue, WE is on.
Release the power button. Push each shift button once to
activate them.
Power Off
Push and hold the power button. The LED lights will blink
blue-red. When the LED lights flash red, WE is off.
WE will also go in to Stand-By mode, and turn off
automatically after a period of inactivity. Those intervals
are customizable in the WE Dashboard Software.
Rear Derailleur Alignment
1. Shift the chain to the small chairing.
2. Shift the rear derailleur to the center (6th) cog.
3. Enter set mode by pushing and holding the SET button
for 2 seconds. Both LEDs will blink green.
4. Press rear shifter button to enter the rear derailleur
adjustment mode (by factory default is the right one but
you can change it in the WE Dashboard Software.)
In this mode, the rear derailleur will operate in micro-
steps.
5. Set the rear derailleur zero position:
a. Rotate the crank and micro-shift the rear derailleur
up until the chain begins to rub on the next cog.
b. Move the RD three micro-steps back.
c. Double check the alignment — The upper jockey
pulley on the rear derailleur should be in line with the
center cog.
6. Exit set mode---push and hold the SET button for 2
seconds. The green light will stop blinking and the rear
derailleur zero position will be saved.