16
Changing the cutting disc (2)
1.
Pull out the power plug.
2.
Unscrew the three screws on the safety hood (8) and
remove it from its position (Fig. 25).
3.
Using the nut wrench (30), loosen the flange nut in the
direction of rotation of the cutting disc (2). (
Note.
Left-
hand screw-thread.) To do so, place the supplied wrench
(30) on the motor shaft and apply counterpressure (Fig.
26).
4.
Remove the outer flange and cutting disc (2) (Fig. 27).
5.
Clean the mounting flange thoroughly before fitting the
new cutting disc.
6.
Fit the new cutting disc by following the above procedures
in reverse and then tighten the flange nut.
7.
Mount the safety hood (8) for the cutting disc again.
Replacing the battery on the laser
1.
Unscrew the 4 screws and remove the base plate. Take out
the old batteries and replace with new ones. Screw the
base plate back on (Fig. 28).
Note.
Always remove the laser before you clean the machine
with water.
MAINTENANCE
Fig. 25
Fig. 26
Fig. 27
Fig. 28
IMPORTANT!
Before cleaning your tile cutting machine or carrying out any
maintenance procedure, make sure that the motor is off and the tile cutting machine
disconnected from the power supply to prevent accidental starting.
CAUTION!
Pay attention to the direction of rotation of the new diamond cutting
disc when mounting!
