13
1.
Pull back and hold quick connector on lance (4) (fig. 10).
2.
Insert spray nozzle (3) and release quick connector (fig. 11).
Note:
Ensure correct fitment to prevent nozzle being forced out of the connector
by water pressure.
3.
To detach, pull back quick connector to eject the spray nozzle.
SETUP & PREPARATION (cont.)
WARNING!
Never place hands in front of nozzle
. Never grasp hose or
fittings during pressure washer operation. Never attempt to attach or
remove spray gun lance or hose fittings while pressure washer system
is pressurized. Stop engine and lock gun trigger before attempting to
change pressure nozzle.
Attaching spray nozzle (3)
Attaching water supply
Fig. 13
Fig. 12
1.
Run water through garden hose to remove any foreign matter before attaching
to the pump (fig. 12).
2.
Attach garden hose (min. I/D ؽ”) to the inlet on the pump (fig. 13).
Note:
The pump requires a minimum water supply of 15 l/min at 20 psi to avoid
damaging the pump due to insufficient water supply.
Fig. 11
Fig. 10
WARNING!
Never let the engine run without water. Failure to do so may
damage the pump
.
