Fukuda Denshi LX-8000 Series, Operation Manual

Page: 85 / 110

61
12. Cleaning and Disinfection
The cleaning and disinfection of the LX-8300M, ECG lead cable, and SpO
2
probe (sensor) shall be performed as follows.
CAUTION
Do not sterilize the LX-8300M, ECG lead cable, and SpO
2
probe (sensor) in
any manners, such as radioactive rays, steam, or ethylene oxide.
■ Cleaning the Housing
1. Clean the equipment using squeezed gauze or an absorbent cotton cloth
dampened with alcohol or a neutral cleanser. When cleaning, do not allow
any solution to enter the equipment or connectors. Also, do not use
organic solvents, thinner, toluene and benzene to avoid damaging the
resin case.
2. In case of dropping the equipment into dirty water, clean it without
disconnecting the ECG lead cable and SpO
2
probe (sensor), and make
sure that the battery compartment lid is locked. After cleaning, wipe off
any moisture thoroughly before removing the ECG lead cable, SpO
2
probe (sensor), or batteries.
CAUTION
 Clean the equipment frequently so stains can be removed easily.
 To prevent injury, it is recommended to wear gloves when cleaning the
equipment.
 Do not allow any chemical solution to enter the LX-8300M or
connectors.
 The LX-8300M cannot be sterilized.
 Do not use organic solvents, thinner, toluene and benzene to avoid
damaging the resin case.
 Do not polish the housing with abrasive or chemical cleaner.
 Use only neutral detergent to clean the housing. Do not use chemical
cloth, scrub brush, abrasive, polishing powder, hot water, volatile
solvent and chemicals (cleanser, thinner, benzine, benzol, and synthetic
detergent for house and furniture), or sharp-edged tools. The surface
resin coating may be damaged, resulting in discoloration, scratches,
and other problems.