En-5
Case 1: For non-polar 2 wire
Remote controller cable
External input cable
Cable tie
(Accessories)
Case 2: For polar 3 wire
Remote controller cable
External input cable
Cable tie
(Accessories)
Fix the connector cable even outside the main unit as necessary.
Fix the cable with cable tie using 3 fixing holes.
Cable tie
(Accessories)
Holes for
fi
xing cable tie (3 places)
7. CONNECTION OF REMOTE CONTROLLER CABLE
CAUTION
When connecting the remote controller cable to the indoor unit, do not
connect it to the outdoor unit or the power terminal block. It may cause a
failure.
Indoor unit
This product
Remote controller cable
When connecting Indoor unit and ex-
ternal switch controller with the Remote
controller cable, the following items
should be considered.
There are 2 methods to connect the remote controller cable to the indoor
unit. One is the connection using contained connecting cable, and the
other is the connection the remote controller cable is connected to the
exclusive terminal block of the indoor unit.
Exclusive terminal block for remote controller connection method is differ-
ent depending on each model. Modify the remote controller cable as per
below description and connect it.
(For the details, refer to the installation manual of the indoor unit to be
used.)
(1)
When connecting to the connector
Case 1: For non-polar 2 wire
Use a tool to cut off the terminal on the end of the remote controller cable,
and then remove the insulation from the cut end of the cable as shown
in Fig. 1. Connect the remote controller cable and connecting cable as
shown in Fig. 2. Be sure to insulate the connection between the cables.
Remote controller
cable (Non-polar)
Insulated
connection
White
Black
20 mm
(13/16 in)
Red
Connecting
cable
Cut and
insulate
Fig.1
Fig.2
Connect the remote controller cable to the connecting cable, and insert
it to the connector. Set to “2WIRE” the DIP switch (SW1) on the PC
board of the indoor unit.
* Layout of Connector and PC
board is varies, depending on
the type of indoor unit.
Set to “2WIRE” the
DIP switch (SW1)
Indoor unit
PC board
Connector
(adapter)
Remote controller
cable (Non-polar)
Connecting cable
Connector CNC01
(onboard)
Connect to earth
(ground) screw
Functional earthing
(If necessary)
SW1
Indoor unit
PC board
9374707157-02_IM.indb 5
9374707157-02_IM.indb 5
12/2/2016 5:22:45 PM
12/2/2016 5:22:45 PM
