Fujitsu Stylistic LT 800P, User Manual

Page: 30 / 102

28
S t y l i s t i c L T 8 0 0 P T a b l e t
To suspend system operation:
1. Press the Suspend/Resume button, or carry out the Standby command from your
operating system or power management program. (If your system is configured
to suspend operation using Save-to-Disk mode, which is explained later in this
procedure, a message is displayed while data is saved to your hard disk.)
The Power icon either flashes (Suspend-to-RAM) or is not displayed (Save-to-Disk)
when system operation is suspended, depending on how your system is configured. At
this point, programs that were running are stopped, active data is saved, and the system
enters one of two different low-power states, or suspend modes, as explained in the
following paragraphs.
2. Observe the Power icon in the Status display to determine which suspend mode
your system is using.
• Power icon is blinking: Suspend-to-RAM mode
In this mode, active data is saved by maintaining power to RAM while most
other system components are powered off. The Battery Gauge icon in the
Status display indicates the battery charge level.
• Power icon is not displayed: Save-to-Disk mode
In this mode, active data is stored on the hard disk drive and power usage is
reduced to the same level used in the Off state. When the system is in Save-to-
Disk mode, the Battery Gauge icon is not visible in the Status display. In this
mode, there is no danger of losing data if battery power is lost.
If you are replacing the battery pack, wait until system is off or system
operation is suspended and the power icon is flashing before you remove
the battery pack. Failure to do so could result in loss of your unsaved data.
58-0867-01.book Page 28 Thursday, February 13, 2003 1:18 PM