Fujitsu SPARC Enterprise M3000, Service Manual

Page: 126 / 202

9-6 SPARC Enterprise M3000 Server Service Manual • March 2012
9.3 Installing a Hard Disk Drive
Caution – If a hard disk drive cannot be inserted smoothly, do not forcibly push the
hard disk drive into the slot. If the HDD is forcibly inserted despite the presence of
any obstruction in a slot or any problems with the connector pin, serious damage
may result.
Caution – Do not insert a hard disk drive into a slot when the eject/lock lever is
closed. If an HDD is inserted in this condition, it stops halfway and becomes difficult
to pull out.
1. Align the hard disk drive with the slot, and then push the hard disk drive in
until it stops.
2. Fasten the eject/lock lever.
9.4 Reassembling the Server
9.4.1 Active Replacement
For active replacement, operation varies by the hard disk drive configuration.
■
In hardware RAID
Check the status of a RAID rebuild in the replaced hard disk drive. For details,
see the
SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers
Administration Guide .
■
In software RAID
See the manuals for the software in use.
■
When hardware RAID and software RAID are not used
Configure the hard disk drive in the domain. This procedure includes the steps of
using the cfgadm command to connect the hard disk drive to the domain, and for
verifying that it has been added to the domain. For details, see
Section 4.3.3,
“Configuring a FRU in a Domain” on page 4-6 .