Fujitsu SCANPARTNER 600C, User Manual

Page: 42 / 95

4-14
4.3.3 SELECTION phase
The SELECTION phase allows an initiator to select a target for the purpose of initiating some target function (e.g.,
READ or WRITE command). During the SELECTION phase the I/O signal is negated so that this phase can be
distinguished from the RESELECTION phase.
1. The SCSI device that won the arbitration has both the BSY and SEL signals asserted and has
delayed at least a bus clear delay plus a bus settle delay before ending the ARBITRATION phase.
The SCSI device that won the arbitration becomes an initiator by not asserting the I/O signal.
2. The initiator shall set the DATA BUS to a value which is the OR of its SCSI ID but and the target's
SCSI ID bit, and it shall assert the ATN signal.
3. The initiator shall then wait at least two deskew delays and release the BSY signal.
4. The initiator shall then wait at least a bus settle delay before looking for a response from the target.
5. The target shall determine that it is selected when the SEL signal and its SCSI ID bit are true and
the BSY and I/O signals are false for a least a bus settle delay. The selected target may examine the
DATA BUS in order to determine the SCSI ID of the selecting initiator; The selected target shall
then assert the BSY signal within a selection abort time of its most recent detection of being
selected; this assertion is required for correct operation of the selection time-out procedure.
The target shall not respond to a selection if bad parity is detected. Also, if more than two SCSI ID
bits are on the DAT BUS, the target shall not respond to selection.
6. No less than two deskew delays after the initiator detects the BSY signal is true, it shall release the
SEL signal and may change the DATA BUS. The target shall wait until the SEL signal is false
before asserting the REQ signal to enter an information transfer phase.
Bus clear delay
+ bus settle delay
Deskew
delay x 2 Deskew
delay x 2
SELECTION phase
I/O
BSY
SEL
DB