Fujitsu SCANPARTNER 600C, User Manual

Page: 25 / 95

3-13
4. Place the document face down on the ADF paper chute, and put the ends of the bottom 2 or 3 sheets into
the auto feeder.
5. C]ose the right and left guides against side of the document. (Skewing may occur if a gap exists between
the guides and document.)
6. Slide the pages down into the chute until they hit the far end of the auto feeder hole.
(a) Angling the document sheets
1. Place the document face down on a flat surface, with the top of the page to the left (a).
2. Lift the sheets with both hands. Take a maximum 4 mm thickness of sheets.
3. Hold the sheets tightly with your left hand and bend the sheets as shown in (b).
4. Then grip tightly with your right hand, loosen the grip of your left hand, and straighten the sheets as
shown in (c).
5. Repeat operations 3 and 4 as often as necessary with the entire document has been angled.
Take a 2 to 4 mm thickness of sheets. Lightly hold both ends with both hands. Bend the sheets as shown.
Hold the sheets tightly with both hands then straighten the sheets. This operation separates the sheets for
easy feeding into the ADF. Repeat this operation two or three times. Turn the stack of sheets over and repeat
the entire operation.
(b) Separating the sheets for easy feeding