TX2540 M1
Operating Manual
19
Functional overview
Accessible drives / components
The server has three 5.25-inch bays.You can use these bays as follows:
– Optical disk drives or backup drives.
– Multibay for a slimline optical disk drive and a Server View Local Service
Display (LSD); occupies one bay.
– 4 x 3.5-inch HDD extension box for up to four additional 3.5-inch SAS/SATA
HDD modules and a slimline optical disk drive; occupies three bays.
– 8 x 2.5-inch HDD extension box for up to eight additional 2.5-inch SAS/SATA
HDD modules; occupies two bays.
Power supply units (PSUs)
The power supply configuration depends on the base unit:
– a standard PSU (800 W)
– one hot-plug PSU (450 W or 800 W)
– two hot-plug PSUs for redundancy
The PSUs adjust automatically to any mains voltage in the range of 100 V -
240 V.
A mix of 450 W and 800 W hot-plug PSUs is not allowed. If one of two hot-plug
PSU is defective, the other guarantees unimpaired operation. The defective
power supply module can be replaced during operation (see the "FUJITSU
Server PRIMERGY TX2540 M1 Server Upgrade and Maintenance Manual").
I
Redundancy is only guaranteed, if the total maximum power of all low
power versions gets not exceeded.
Summary of Contents for PRIMERGY TX2540 M1
