36
Chapter 1 Overview
1.4.4 Turning Off the Server
1
Slide the drive cover.
"1.4.1 Sliding the Drive Cover" (pg.31)
2
Make sure that the floppy disk drive and CD-ROM drives are empty.
3
Shut down the OS.
In the following cases, the server is turned off after the OS is shut down (Step 4 is not necessary).
• Windows OS
• ServerView is installed
In other cases, make sure that the floppy disk and hard disk access LEDs are off when the OS is
shut down.
4
Press the power switch on the front of the server.
The server's power LED is lit amber.
5
Turn off the display and peripheral devices.
The time to turn the server off can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView. For details, refer to
"
3.2 Settings for Server Monitoring
"
in
"
ServerView User’s Guide.
"
To turn the power off completely, turn the main switch on the rear of the server to
"
0
"
(for the standard
power supply) or remove the power plug from the outlet.
• Follow the procedures below to turn off the server. Data can be lost if
these procedures are not followed correctly.
• In the event of smoke or sparks, immediately unplug the electric cord.
Failure to do so could lead to a fire or electrocution.
• Be sure to wait for 10 seconds or more after shutdown before turning the
server on.
The servers power
LED is lit amber
Summary of Contents for PRIMERGY TX200 S2
