Fujitsu PRIMERGY TX1320 M4, Upgrade And Maintenance Manual

Page: 335 / 372

TX1320 M4
Upgrade and Maintenance Manual 335
Appendix A
15.2.4 Acoustic indicators
PEI Beep Codes
Pre-EFI Initialization (PEI) - memory Initialization (bootblock)
DXE Beep Codes
Driver Execution Environment (DXE) - main hardware Initialization (POST)
# of
Beep Description Action
1 Memory not installed
Ê
Check if the memory module is installed.
Ê
Check if the memory module is installed
correctly.
2 Recovery started Recovery procedure is initialized by jumper
settings on the system board and announced
with two beep.
This is only an information.
4 Recovery failed
Ê
Restart the recovery procedure again.
Ê
If the same beep code sounds again,
replace the system board.
# of
Beep Description Action
1 Invalid password
Ê
Check for the correct password and try
again.
Ensure that the caps lock key is
deactivated.
5 No Console Input
devices1 or Output
devices2 are found Booting will continue.
1 Serial console redirection is considered a
console output device if enabled.
2 Serial console redirection is considered a
console input device if enabled.
This beep code is only an information.