Fujitsu PRIMERGY RX2560 M1, Operating Manual, Page: 53 / 94

TX2560 M1 / RX2560 M1
Operating Manual 53
Hardware installation
5.2 Setting up the floorstand model
I
If you are not installing a PRIMERGY TX2560 M1 floorstand model, skip
this section and continue reading at section
"Installing/removing the rack
model" on page 54 .
V
CAUTION!
Please note the safety instructions in chapter "Important information" on
page 37 .
Ê
Transport the server to the place where you want to set it up.
Ê
Unpack the server (see section "Unpacking the server" on page 52 ).
Ê
Set up the server.
V
CAUTION!
– The device must be protected from direct sunlight.
– The required minimum distances for operation and maintenance
areas must be adhered to.
– The server must be accessible at the rear for connection to other
devices (e.g. memory subsystem).
– The mains plug must be accessible easily and safely.
– There must be a clearance of at least 200 mm in front of and
behind the server to ensure adequate ventilation of the
subsystem.
Ê
Wire the server. Read the information in section "Connecting devices to the
server" on page 56 and section "Notes on connecting/disconnecting cables"
on page 60 .
Ê
Connect the system to the mains (see section "Connecting the server to the
mains" on page 58 ).