E
3
3 Notes on Settings
●
If the setting pins need to be changed, use caution to prevent damage to the PC board
beneath them.
●
Do not touch any other pins and/or switches other than the SCSI ID/Terminator setting
pin.
4 Notes on Handling
▲
CAUTION
!
The hard disk is a precision device. Strictly observe the following when handling the prod-
uct; otherwise, the product and/or the data in the disk may be destroyed.
●
Do not touch the connector section and/or the component installation surface of the PC
board when handling the product.
●
Be sure not to drop or mishandle the product in any way until the bottom of the product
completely touches the desk surface when the product is to be placed on the desk.
●
Before carrying out the following operation, turn off the power and wait until the disk
completely stops rotating (about 30 seconds).
– Removing this product
– Changing the settings
●
Do not use or store the product in the following locations:
– Near a magnet or strong magnetic field
– Near a heater or anywhere the product would be exposed to direct sun light
– Any location subject to extreme temperature or humidity changes
– Any wet or dusty location
– Any location subject to vibration or shock
●
Use a soft dry cloth to wipe dust from the product. Do not use volatile agents such as
benzine or thinner.
●
Do not disassemble the product.
●
Do not touch pins other than the setting pins.
