16
To connect an S-Video cable:
1.
Connect the cable to the video output jack on the external device.
2.
Connect the cable to the video input jack on the notebook (See Figure 12).
3.
Connect the audio cable between the external device and the notebook, as described in
“Connecting an External Audio Device” on page 14.
Figure 12. S-Video Cable Connection
SETTING UP INSTANT MYMEDIA
When using Instant MyMedia for the first time, setup will begin automatically after Instant
MyMedia is activated. Follow the steps below to complete installation.
1.
Verify that the system is not powered on, then press the MyMedia button on the remote
control. During the first portion of the installation, the notebook will cycle through several
The S-Video connector is keyed so that it can only be inserted when it is aligned
properly with the port. Be sure to examine the orientation of the connector with
the port before inserting it. Forcible insertion may cause damage to the connector
and/or port.
When performing the installation, do not wear headphones initially; the volume
may be greater than expected.
Be sure to follow the steps indicated below. Attempting to install Instant MyMedia
using different steps could result in failure to start. Note that Instant MyMedia will
cause the system to reboot twice during this installation procedure. If Instant
MyMedia fails to start after following these steps, refer to the Troubleshooting
section of this manual.
S-Video Cable
S-Video Port
TVTuner.book Page 16 Friday, October 8, 2004 1:32 PM
