Fujitsu MCJ3230AP, Product Manual

Page: 168 / 199

Operation and Cleaning
5-4 C156-E205-01EN
4) Push the cartridge into the slot until it completes moving below (a little
further in than the operator panel).
The cartridge remains inserted in the drive. The BUSY LED indicator lamp lights
when the drive power is turned on.
The cartridge remains inserted in the drive. Turning on the drive power starts
loading. (The LED indicator lamp should light.)
Notes
1) If the BUSY LED indicator lamp does not light when the power is turned
on, once eject the cartridge by pressing the eject button and insert it again
until the lamp is lit.
2) If the cartridge is inserted by pushing either left or right side of the
cartridge rear, it may not be inserted completely. Be sure to push the
central part straight into the drive until it is completely inserted.
3) If you attempt to insert the cartridge by force, trouble may result in the
drive. In such a case, be sure to once remove the cartridge and check the
insertion direction and the face and back of the cartridge before inserting
it again.
Figure 5.2 Inserting cartridge
Even if you inserted the optical disk cartridge by pressing the left
side of the rear edge with the cartridge shutter surface facing
upward, and you heard a chucking sound, the device may not enter
the READY state. In such case, press the center of the rear edge of
the cartridge (check the dint part on the front side of the panel)
further, until the LED indicator lamp goes on. This lamp indicates
that the cartridge is normally inserted.
Inserting direction
Shutter Push by hand the width of 20mm to the right and left
from the cartridge rear center, to the position shown at
right.