Fujitsu MBA3073FD, Product Manual

Page: 62 / 106

Installation
5.3 Mounting HDDs
5.3.1 Mounting procedures
Since mounting the HDD depends on the system cabinet structure, determine the work procedures
considering the requirements specific to each system. The general mounting method and items to be
checked are shown below.
See Section 4.1 for the details of requirements for installing the HDDs.
1) Fix the HDD in the system cabinet with four mounting screws as follows:
•
The HDD has 10 mounting holes (both sides: 3
×
2, bottom: 4). Fix the HDD by using
four mounting holes of both sides of the HDD or the bottom.
•
Use mounting screws of which lengths inside the HDD are 4.5 mm
±
0.8 mm when the
screws are tightened (see Figure 4.3).
•
When mounting the HDD, be careful not to damage parts on the PCBA.
2) Confirm the DE is not touching the frame on the system side excluding the screw installing part
after tightening the screws. At least 2.5mm of clearance is required between the DE and the
frame. (see Figure 4.3)
3) When using an electric screwdriver, use the screwdriver that does not apply a force on the HDD
that would exceed the HDD specifications.
56 C141-E264