MB91F465XA EMULATION
Chapter 4 Softune Workbench
MCU-AN-300015-E-V11
- 22 -
© Fujitsu Microelectronics Europe GmbH
When starting the debug session the compiled binary file (\EMULATOR\ABS\*.abs) is
automatically downloaded to the emulator. Afterwards the procedure file
set_cs.prc
in the
PRC folder is executed. This file sets up and activates chip select area
CS3
. The FlexRay
communication controller MB88121B is connected at CS3.
By asserting Reset during debugging the MB91V460A is reset. Also CS3 is getting inactive.
To activate it again the customize button 1 can be used. By pressing the button the
set_CS3.prc will be executed, which initialises CS3.
Click on customize button 1 to execute set_CS.prc after asserting Reset.
Figure 4-5: Emulator Debug session, use Customize button 1
If the customize buttons are not visible, activate them via “View -> Customise bar -> View”
Figure 4-6: View customize bar
After the project is built and debugged successfully switch to the active configuration
STANDALONE
