Fujitsu Lifebook L470, Manual

Page: 146 / 204

S e c t i o n F i v e
132
EXTERNAL MONITOR
You may install an external monitor on the
external monitor port on the rear panel of your
notebook. Make sure that the wide side of the
connector is up and attach it to the port by
pushing in until it is seated, then tighten the
hold-down screw on each end of the connector.
(Figure 1-7 on page 8.)
C A U T I O N
Pressing F10 while holding down the Fn
key allows you to change your selection
of where to send your display video. Each
time you press the combination of keys
you will step to the next choice. The choic-
es, in order, are: built-in display panel only,
external monitor only, or both built-in dis-
play panel and external monitor.
THEFT PREVENTION LOCK
A physical security system lock can be installed
on the right side of your notebook. (See Figure
1-6 on page 6 for the location of the lock slot.)
Simply insert the key end of your security
system in the slot, rotate 90 degrees and lock.
MEMORY UPGRADE MODULE
Your notebook has 64MB of installed SDRAM.
To increase your memory capacity you may
install a memory upgrade module in the
memory upgrade compartment in the bottom
of your notebook. A memory upgrade module
is a dual-in-line memory module (DIMM).
You may add a module of different capacity.
SDRAM memory upgrade modules are required.
To Install a Memory Upgrade Module
1. Turn off power to your notebook using the
power switch, (see Power Off on page 22),
and remove any power adapter (AC or
auto/airline).
2. Make sure that all the connector covers
are closed.
3. Turn the notebook bottom side up, with the
front panel toward you.
4. Remove the screw of the memory upgrade
compartment. (Figure 5-21.)
C A U T I O N
Never remove screws except the ones
specifically shown in the directions for
installing and removing the memory
upgrade module.
Figure 5-20 L Series Memory Upgrade Compartment
Memory Upgrade
Compartment