Chapter 8 Operational Settings
173
Specifying the Area to Detect Multifeed
[Document check area specification for Multifeed
Detection]
The following setting is only available when you specified
[Check Overlapping (Ultrasonic)].
1
From the listing on the left, click [Device Setting 2]
[Document check area specification for Multifeed
Detection].
Select the [Selected range] check box in the dialog box.
2
Specify the detection range.
Range
Description
Selected range
Select the check box to specify the
detection range (colored in light blue) in the
picture below.
Select the check box to enable the setting in
this window. Clear the check box to disable
the setting. Clearing this check box sets
both the start and the end positions to "0",
making the whole document to be detected
for multifeeds.
The above condition applies when the
document is set to the center of the pick
roller width.
Disable
(Left/Middle/Right)
Does not detect multifeeds for the selected
area.
Enable
(Left/Middle/Right)
Detects multifeeds for the selected area.
Start
(Left/Middle/Right)
Displays the starting point of the detection
by the length from the leading edge of the
document.
Configurable area: 0 to 510 mm (in
increments of 2 mm), Start < End
35
35
35
60
60
F
e
edi
ng dir
e
ct
ion
Unit: mm
Detected
Sheet
Left Middle Right