D3141 (RX600 S6)
Technical Manual
53
4
Replacing the lithium battery
To allow permanent saving of the system information, a lithium battery is
installed which supplies the CMOS memory with power. If the battery voltage is
too low or the battery is empty, a corresponding error message is displayed. The
lithium battery must then be replaced.
V
CAUTION!
The lithium battery must be replaced with an identical battery or with a
battery type recommended by the manufacturer. In the Japanese market
only the Fujitsu service partner can replace the lithium battery.
Do not throw lithium batteries into the trash can. They must be disposed
of in accordance with local regulations on special waste.
Make sure you insert the lithium battery the
right way round
–
the
positive pole must be on the housing side!
Figure 23: Replacing the lithium battery (boards removed for clarity)
Ê
Press the metal clip in the direction of the arrow (1) and remove the battery
from its holder (2).
Ê
Take an identical lithium battery, press the metal clip in the direction of the
arrow (3), and insert the new lithium battery into the holder (4).
Ê
Dispose of the waste battery as described above.
+
+
1
2
4
3
