Installing the NAS
Installing the NAS
For information on hard disk installation and initial operation, please refer to the "Quick Start Guide".
To make sure that the NAS works correctly, pay attention to LEDs and
alarm buzzer sounds during installation.
To install the NAS, proceed as follows:
►
Switch on the NAS.
►
Connect the NAS to the same network as your PC.
See
"System status checks", Page 15
for more information.
List of recommended hard disks
This product will work with 2.5/3.5 inch SATA hard disks from major hard disk manufacturers.
For a list of compatible hard disks, see
"http://support.ts.fujitsu.com"
.
Fujitsu Technology Solutions will accept no liability whatsoever for any product
defects/faulty operation, and/or any time and costs associated with data loss/data
recovery, insofar as the cause can be attributed to misuse or improper installation
of hard disks, regardless of the circumstances or for whatever reason.
When installing a hard disk (new or used), which has not yet been installed
on the NAS, please note that this will
fi
rst be formatted and subdivided
automatically and all disk data will be deleted.
System ventilation
When setting up the device, ensure that suf
fi
cient ventilation will be available at all times. The air
inlets on the product must not be covered, as otherwise it is not possible to guarantee that the
system will receive suf
fi
cient ventilation, which may lead to the product being damaged.
14
Fujitsu
