En-14
[Example]
Remote
controller cable
Box
Screws
Connector
Rear case
Earth (Ground) the remote controller if it has an earth (a ground) wire.
Wrap the connector and remote
controller wires with vinyl tape
or some other type of insulation
as shown in the fi gure.
Remote controller
30
120
17
120
45.3
33.5
Hole
15.3
23
8
4.5
4.5
4.5
12.5
Hole × 3
Hole × 2
83.5
63.5
6
Unit: mm
CAUTION
Install the remote controller wires so as not to be direct touched with your hand.
Do not touch the remote controller PC board and PC board parts directly with your
hands.
7.2. Setting the dip switches
Set the remote controller DIP switches.
[Example]
ON
ON
OFF
1
2
3
4
5
6
DIP switch 1
Front case (back side)
NO.
SW state
Detail
OFF
ON
DIP-
switch 1
1
★
Cannot be used.
(Do not change)
2
★
Dual remote controller setting
* Refer to 2. DUAL REMOTE CONTROL-
LERS in 7.5. Special Installation Methods.
3
★
Cannot be used.
(Do not change)
4
★
Cannot be used.
(Do not change)
5
★
Cannot be used.
(Do not change)
6
★
Invalidity
Validity
Memory backup setting
* Set to ON to use batteries for the memory
backup. If batteries are not used, all of the
settings stored in memory will be deleted if
there is a power failure.
(
★
Factory setting)
7.3. Function setting
This procedure changes the function settings used to control the indoor unit according to
the installation conditions. Incorrect settings can cause the indoor unit to malfunction. This
procedure should be performed by authorized installation or service personnel only.
Perform the “FUNCTION SETTING” according to the installation conditions using the remote
controller. (Refer to the indoor unit installation manual for details on the function numbers
and setting values.)
(1) Press the SET TEMP. buttons (
) ( ) and FAN button simultaneously for more than
5 seconds to enter the function setting mode.
SU MO TU WE TH FR SA
(2) Press the SET BACK button to select the indoor R.C. address.
SU MO TU WE TH FR SA
R.C. address of INDOOR UNIT
SET BACK
(3) Press the SET TIME (
) buttons to select the function number.
Function number
SU MO TU WE TH FR SA
9374342235-02_IM.indb 14
4/2/2012 2:36:39 PM
AMP Air Conditioning
www.ampair.co.uk | [email protected]
