- (01 - 26) -
FL
OO
R T
YP
E
A
G
G
09
-1
4LV
C
A
FL
OO
R T
YP
E
A
G
G
09
-1
4LV
C
A
REMOTE CONTROLLER SIGNAL CODE SETTING
Use the following steps to select the signal code of the remote controller.
(Note that the air conditioner cannot receive a signal code if the air conditioner has
not been set for the signal code.)
Press the START/STOP button until only the clock is displayed on the remote
1.
controller display.
Press the MODE button for at least five seconds to display the current signal code
2.
(initially set to ).
Press the SET TEMP. (
3.
) ( ) button to change the signal code between →
→ → .
Match the code on the display to the air conditioner signal code.
Press the MODE button again to return to the clock display. The signal code will
4.
be changed.
If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original
clock display. In this case, start again from step 1.
The air conditioner signal code is set to A prior to shipment.
Contact your retailer to change the signal code.
The remote controller resets to signal code A when the batteries in the remote controller are replaced. If you use
a signal code other than signal code A, reset the signal code after replacing the batteries. If you do not know the
air conditioner signal code setting, try each of the signal codes ( → → → ) until you find the code which
operates the air conditioner.
Summary of Contents for AG*G09LVCA
Page 2: ...1 INDOOR UNIT FLOOR TYPE AG G09LVCA AG G12LVCA AG G14LVCA DTR_AG005E_02 2013 07 19 ...
Page 31: ...2 OUTDOOR UNIT SINGLE TYPE AO G09LVCA AO G12LVCA AO G14LVLA DTR_AO129E_01 2012 12 04 ...
Page 37: ... 02 05 OUTDOOR UNIT AO G09 14LV OUTDOOR UNIT AO G09 14LV MODEL AO G14LVLA ...
Page 45: ... 02 13 OUTDOOR UNIT AO G09 14LV OUTDOOR UNIT AO G09 14LV SOUND LEVEL CHECK POINT 88888 ...
