S e c t i o n F o u r
78
8. Insert the RAM Module at a 45° angle.
(Figure 4-2.) Press the connector edge of the
module firmly down and into the connector.
9. Press the RAM Module down into the com-
partment until it lodges under the retaining
clip. You will hear a click when it is properly
in place.
10. Replace the keyboard by aligning the tabs at
the top of the keyboard with the holes in the
notebook body and closing the keyboard
down until it fits flat and the top of the
keyboard is tight against the body of
the notebook.
11. Replace the two screws.
12. Close the tabs at the bottom of the keyboard
and push firmly until they snap.
Removing the RAM Module
The RAM Module is not something you rou-
tinely remove from your notebook.Once it is
installed, you can leave it in place unless you
want to increase RAM capacity.
C A U T I O N
Do not attempt to install or remove a RAM
Module if he notebook has been re c e n t l y
used. The surface areas under the key-
b o a rd can be very hot, and may injure you.
To Remove the RAM Module:
1. Perform steps 1 through 5 of Installing the
RAM Module.
2. Pull clips sideways from each side of the
RAM Module.(Figure 4-3).
3. While holding clips out, remove the module
from the slot by lifting it up and pulling
towards the front edge of the notebook.
4.Store the RAM Module in a static guarded
sleeve.
5. Replace the keyboard by following the
instructions in steps 10 through 12 of the
instructions for Installing the RAM Module,
or install a new RAM Module and then
replace the keyboard by following the
instructions in steps 6 through 12 o f the
instructions for Installing the RAM Module.
Figure 4-3 Removing the RAM Module
C A U T I O N
Before you install or remove the RAM
Module, save changes and close all
files. Turn power off to your notebook.
(
See Power Off on Page 23.
)
Summary of Contents for 420D
Page 3: ...T a b l e o f C o n t e n t s ...
Page 149: ...I n d e x ...
